2. Razor
  3. W15128785133
W15128785133

Razor W15128785133 User manual

  • Hello! I've reviewed the document for the Rambler 16 headlight holder replacement. It seems to be a straightforward guide with clear steps and tool requirements. I'm ready to answer any questions you have about the replacement process or the tools needed.
  • What tools are needed for the replacement?
    What is the first step in the replacement process?
    What is the second step in the replacement process?
Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.
1
WARNING
Step 1 Step 2
Required Tools: (Not included)
A. 3 mm Allen wrench
B. 8 mm wrench
C. Phillips screwdriver
CAUTION: To avoid potential shock or other injury, turn power switch OFF and disconnect
charger before conducting any assembly or maintenance procedures. Failure to follow these
steps in the correct order may cause irreparable damage.
Using a 3 mm Allen wrench and a 8 mm wrench, loosen
and remove the bolt and lock nut at the back of the
headlamp.
Using a Phillips screwdriver, remove the two (2) screws that
hold the headlamp holder onto the front fork.
RAMBLER 16 HEADLIGHT HOLDER
REPLACEMENT INSTRUCTIONS
PART # W15128785133/W15128701133
Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.
2
Step 3
Reverse the steps.
ATTENTION: Charge battery 12 hours before using.
/