RF Single Color Wall Mounted Controller 09.28T2I.04272
Zone 1
Function introduction
Important: Read All Instructions Prior to Installation
Front side
Zone 3
Zone 2
Zone 4
Click to turn on/off, press and hold down
to increase/decrease light intensity
19.50 mm 71.00 mm
53.00 mm
Output Signal RF signal
Power Supply 12-24VDC
Power consumption 200 mA
Operating temperature 0-40°C
Relative humidity 8% to 80%
Dimensions 120x80x29.1mm
RF RGBW Color
Wall Mounted Controller
Back side
83.00 mm
101.00 mm
• Touch sensitive
• Glass interface(white & black)
• Control single color
• Control 4 zones synchronously and separately
• Compatible with all universal series RF receivers, radio frequency: 868/869.5/434MHz
• Back lighting for finding in the dark
• Waterproof grade: Ip20
Product Data
• DO NOT install with power applied to device.
• DO NOT expose the device to moisture.
Safety & Warnings
Wiring diagram
DC Power input
12-24VDC
PSU
AC 100-240V
DC INPUT
V+ V+ V- V-
L L NN
AC INPUT
DC Version
AC Version
AC Power input
RF signal
100-240VAC
15 mA
0-40°C
8% to 80%
120x80x29.1mm
DC Version AC Version
RF RGBW Color
Wall Mounted Controller
DC IN PUT
V+ V+ V- V-
RF RGBW Color
Wall Mounted Controller
L L NN
AC IN PUT
DC Version AC Version
AC 100-240V
AC Power
50/60Hz
AC Power
50/60Hz
Installation
Pair with RF receiver
Step 2:Click the “Learning Key” button on RF receiver or re-power on the
receiver three times continuously to set it into pairing status
Learning Key
RF LED Receiver
Step 1:Do wiring the wall panel & RF receiver according to wiring diagram
(please refer to the instruction of RF receiver that you would like to pair with)
Step 3:Choose one zone and touch button of the zone(e.g. zone 4),
LED lights connected with the RF receiver flicker once means the
receiver is paired with zone 4 successfully.
①
②
/
