2. Sunricher
  3. SR-2801

Sunricher SR-2801 User manual

  • Hello! I've reviewed the user manual for the Sunricher SR-2801 RF Single Color Remote Controller. This manual provides instructions on how to pair the remote with RF receivers, control 5 zones separately, and adjust the light intensity. I'm ready to answer any questions you might have about this device.
  • What is the operating temperature range of the device?
    How many receivers can a single remote control pair with?
    What is the power supply for the remote controller?
    What is the waterproof grade of the remote controller?
RF Single Color Remote Controller
Pair with RF receiver
Zone 1:Click to turn on,
Press and hold down to increase
light intensity
09.283K5.04205
Note:Before the first use, please remove the protective film on the battery.
Function introduction
Important: Read All Instructions Prior to Installation
Output RF signal
Operation Frequency
868/869.5/916.5/434MHz
Operating temperature 0-40°C
Relative humidity 8% to 80%
Dimensions 136.3x38.9x10.7mm
Front side
Back side
• Control 5 zones of receivers separately
• Single color controller
• Compatible with all universal series RF receivers
• 1 receiver can be paired by max 8 different remote controls.
• Waterproof grade: IP20
Product Data
• This device contains a button lithium battery that shall be stored and disposed properly.
• DO NOT expose the device to moisture.
Safety & Warnings
Power Supply 3V(1xCR2025 battery)
Zone 2:Click to turn on,
Press and hold down to increase
light intensity
Zone 3:Click to turn on,
Press and hold down to increase
light intensity
Zone 4:Click to turn on,
Press and hold down to increase
light intensity
Zone 5:Click to turn on,
Press and hold down to increase
light intensity
Zone 1:Click to turn off,
Press and hold down to decrease
light intensity
Zone 2:Click to turn off,
Press and hold down to decrease
light intensity
Zone 3:Click to turn off,
Press and hold down to decrease
light intensity
Zone 4:Click to turn off,
Press and hold down to decrease
light intensity
Zone 5:Click to turn off,
Press and hold down to decrease
light intensity
Step 3:Choose one zone and click or of the zone(e.g. zone 5),
LED lights connected with the RF receiver flicker once means the receiver is
paired with zone 5 successfully.
Step 2:Click the “Learning Key” button on RF receiver to set it into pairing status
Note: one receiver can be paired with max 8 remote controls.
Learning Key
RF LED Receiver
Step 1:Do wiring the RF receiver according to wiring diagram(please refer to the
instruction of RF receiver that you would like to pair with.
After pairing, click or hold or of 1/2/3/4/5 to control each zone separately
If you use multiple receivers, you have two choices:
Option 1: have all the receivers in the same zone, like zone 1
Lear ning K ey
RF LED Re ceive r
Zone 1
Option 2: have each receiver in a different zone, like zone 1, 2, 3 or 4
Zone 1 Zone 2 Zone 3
RF remote
RF remote
Lear ning K ey
RF LED Re ceive r
Lear ning K ey
RF LED Re ceive r
Lear ning K ey
RF LED Re ceive r
Lear ning K ey
RF LED Re ceive r
/