Page is loading ...
RF Single Color Wall Mounted Controller 09.28T1I.04209
Zone 1
Function introduction
Important: Read All Instructions Prior to Installation
Front side
Zone 2
Click to turn on,
press and hold down
to increase light intensity
Click to turn off,
press and hold down to
decrease light intensity
19.50 mm 71.00 mm
53.00 mm
Output Signal RF signal
Power Supply 12-24VDC
Power consumption 200 mA
Operating temperature 0-40°C
Relative humidity 8% to 80%
Dimensions 120x80x29.1mm
RF RGBW Color
Wall Mounted Controller
Back side
83.00 mm
101.00 mm
• Touch sensitive
• Glass interface(white & black)
• Control single color
• Control 2 zones synchronously and separately
• Compatible with all universal series RF receivers, radio frequency: 868/869.5/434MHz
• Back lighting for finding in the dark
• Waterproof grade: Ip20
Product Data
• DO NOT install with power applied to device.
• DO NOT expose the device to moisture.
Safety & Warnings
Wiring diagram
DC Power input
12-24VDC
PSU
AC 100-240V
DC INPUT
V+ V+ V- V-
L L NN
AC INPUT
DC Version
AC Version
AC Power input
RF signal
100-240VAC
15 mA
0-40°C
8% to 80%
120x80x29.1mm
DC Version AC Version
RF RGBW Color
Wall Mounted Controller
DC IN PUT
V+ V+ V- V-
RF RGBW Color
Wall Mounted Controller
L L NN
AC IN PUT
DC Version AC Version
AC 100-240V
AC Power
50/60Hz
AC Power
50/60Hz
Installation
Pair with RF receiver
Step 2:Click the “Learning Key” button on RF receiver or re-power on the
receiver three times continuously to set it into pairing status
Learning Key
RF LED Receiver
Step 1:Do wiring the wall panel & RF receiver according to wiring diagram
(please refer to the instruction of RF receiver that you would like to pair with)
Step 3:Choose one zone and touch or button of the zone
(e.g. zone 2), LED lights connected with the RF receiver flicker once
means the receiver is paired with zone 2 successfully.
①
②
/
