JADEMAR LIGHTING Jbl-Cps Series User manual

• Risk of electric shock--Disconnect power to equipment before installing or servicing.

• This equipment must be installed according to all applicable codes & ordinances.

• Installaon and service of this equipment must be performed by qualiﬁed service personnel.

• Read these instrucons before installing, servicing or maintaining this equipment.

• Save these instrucons for maintaining and servicing.

• The installer must ensure that the foundaon is stable and can support the luminaires weight.

• The Installer must use proper means to secure the luminaire to the ground.

WARNING BEFORE YOU BEGIN READ THESE INSTRUCTIONS COMPLETELY AND CAREFULLY.

JBL-CPS SERIES

INSTALLATION INSTRUCTIONS

WWW.JADEMAR.COM

Miami, FL USA - info@jademar.com

T: 305.640.0465 - F: 305.640.0468 Revised 07/2023

Page 1 of 2

FOR

HAZLOC

1.0 INSTALLATION INSTRUCTIONS - PREPARATION & INSTALLATION

JBL-CPS SERIES CCT & POWER SELECTABLE BOLLARD

Step 1: Remove the luminaire (Figure 1) and accessories (Figure 2) from the carton and

inspect luminaire for damage. Do not install a damaged luminaire.

• Edges may cut--wear gloves while handling or servicing this equipment.

• Inspect equipment for damage from shipping and handling.

• Recommended cleaning substances:

▪Wipe oﬀ dust with a dry, so cloth. Remove greasy spots etc. with a so cloth dampened in lukewarm water (<122°F/ 50°C) with a mild detergent.

▪Never use detergents containing abrasives and solvents.

▪Warning: Scouring powder and similar substances will scratch surfaces.

CAUTION RISK OF FIRE, ELECTRIC SHOCK, INJURY OR PROPERTY DAMAGE

Bollard Fixture

Figure 1

Anchor Bolt Carrier

Nut

Flat Washer

Spring Washer x3

Figure 2

Figure 4

1-1/2~2”

Figure 3

Step 2: Prepare site. Get the anchor bolt carrier assembled as (Figure 3) and use it to

determine placement of anchor bolts in concrete. Ensure that concrete base is suitable for

the bollard load. Install three anchor bolts into concrete as per aached drawing, having at

least 1-1/2~2” protruding from concrete with threads free and clear of debris and dirt.

(Figure 4)

hex wrench

Figure 6 Ground

Figure 5

Step 3: Dis-assembly the ﬁxture by loosening the set screws x3 with hex wrench. (Figure 5)

Lay the ﬁxture down by the side of the installed anchor bolts. Keep the wires connected.

(Figure 6)

5 Port Terminal Block

Ground Supply Wire

Support Bracket (12inches)

Concrete Base

(by others)

Electrical Conduit

(by others)

Dim-

Ground

Figure 7

Step 4: Place bollard base plate over anchor bolts and ghten nuts securing the base plate

to the foundaon. As the wires shown on (Figure 7) will not be disconnected during

installaon, so please double check to make sure they are in good connecon aer the

base installaon.

2.0 INSTALLATION INSTRUCTIONS - BOLLARD ANCHOR BOLT GUIDE

Step: 5 Put back the ﬁxture body, and ghten the set screws x3 with hex wrench. (Figure 8)

Figure 10

Supply Line

Supply Neutral

Supply Ground

0-10V Dim+

Black Wire

LED BOLLARD

0-10V Dim-

White Wire

Green Wire

Purple Wire

Gray Wire

Figure 9

12W

16W

22W

3000K

4000K

5000K

Labels

Loosen 4 screws,

open the top of the ﬁxture

Figure 8

DIAL SWITCHES DIAGRAM

WIRING DIAGRAM