INSTALLATION REQUIREMENTS
Make electrical and grounded connecons in accordance with the naonal electrical code and any applicable code. Always turn off the power supply before
installaon. This product must be installed in accordance with the applicable installaon code by a qualified electrician who is familiar with the construcon and
operaon of the product and the hazards involved.
WARNING: Read this instrucon carefully before installaon. Keep it for further reference.
PFL-G2 FLOODLIGHT GENERATION 2
WWW.JADEMAR.COM
Miami, FL USA - info@jademar.com
T: 305.640.0465 - F: 305.640.0468 Revised 12/2020
Page 1 of 8
INSTALLATION INSTRUCTIONS
• Risk of fire or electric shock. Fixture installaon requires knowledge of luminaires electrical systems. If not qualified, DO NOT aempt installaon.
Contact a qualified electrician.
• Risk of fire or electric shock. Suitable for wet locaons. Always turn off the power supply before installaon.
• Risk of fire or electric shock. Suitable for non-insulated surface and frame. DO NOT cover fixture with insulaon liner or similar material.
• DO NOT install fixture on unstable, loose or easily breakable surface.
• DO NOT exert force on the surface of the fixture.
INTRODUCTION
This LED Flood light uses the latest in solid state lighng technology for long life, low maintenance, and high efficiency.
The same as tradional HID lighng. 80~400W there are five different mounng opons, suitable for various occasion.
Use100-277V&277-480V, 50/60Hz AC supply.
Suitable for using in the following locaons:
ŸAmbient Temp
Ÿ40~+40°C Wet Locaons
Note: Save these instrucons for future reference
MODEL INPUT VOLTAGE WATTAGE INPUT CURRENT MAXIMUM WEIGHT
PFL-100W 100-277VAC 100W 1.1A 6.62LBS
PFL-100W-H 277-480VAC 100W 0.5A 7.15LBS
PFL-150W 100-277VAC 150W 2A 7.19LBS
PFL-150W-H 277-480VAC 150W 0.8A 7.63LBS
PFL-230W 100-277VAC 230W 2.7A 8.26LBS
PFL-230W-H 277-480VAC 230W 1.8A 8.67LBS
PFL-300W 100-277VAC 300W 4A 11.17LBS
PFL-300W-H 277-480VAC 300W 1.5A 12.22LBS
PFL-400W 100-277VAC 400W 4.8A 14.13LBS
PFL-400W-H 277-480VAC 400W 1.95A 15LBS
MODEL NUMBER PARAMETER LIST
WARNING:
• To avoid the risk of fire, explosion, or electric shock, this product should be installed, inspected, and maintained by a qualified electrician only, in
accordance with all applicable electrical codes.
• All the products can not be installed on woods.
• To avoid the risk of fire, explosion, or electric shock, this product should be installed, inspected, and maintained by a qualified electrician only, in
accordance with all applicable electrical codes.
• All the products can not be installed on woods.
• To avoid explosion: Make sure the supply voltage is the same as the rated luminaire voltage.
• Do not install where the marked operang temperatures exceed the ignion temperature of the hazardous atmosphere.
• Do not operate in ambient temperatures above those indicated on the luminaire nameplate.
• Keep lens ghtly closed when in operaon.
•For supply connecons use wire rated for at least 90°C
