ACCESSORY INSTALLATION
INSTRUCTIONS
COOLER CUSHION
Installation Instructions for the 150 & 170 Super Sport
Issue Date
05/07/2010
Rev:C
PROCEDURE NO.
AI-MS-013
1. PURPOSE
Provide step-by-step procedure for the cooler
cushion installation.
2. SCOPE
This procedure is limited to the cooler cushion installation on the 150 & 170 Super Sport.
3. DEFINITION
3.1. Not Applicable
4. RESPONSIBILITY
4.1. Not Applicable
5. TOOLS/EQUIPMENT REQUIRED
5.1. Drill
- Phillips head bit#2
- 1/8” drill bit
5.2. Pencil
5.3. Hardware Kit (supplied)
6. SAFETY
6.1. Safety glasses or goggles are recommended.
7. FORMS
7.1. Not applicable
CONTENTS OF KIT PART #
COOLER CUSHION.......................................1950784
HARDWARE PKG............901BWCOOLERCUSHION
Page 1 of 3
ACCESSORY INSTALLATION
INSTRUCTIONS
COOLER CUSHION
Installation Instructions for the 150 & 170 Super Sport
Issue Date
05/07/2010
Rev:C
PROCEDURE NO.
AI-MS-013
8. PROCEDURE
8.1. Lay the cushion in place.
8.1.2. Starting on the corner of the cushion, and
using the pencil, make a mark on the cooler lid
just under each snap on the four corners of the
cushion.
8.1.3. Remove the cushion and using the 1/8” drill bit,
drill a pilot hole at each mark made in the
previous step.
NOTE: DO NOT drill through the lid.
Page 2 of 3
ACCESSORY INSTALLATION
INSTRUCTIONS
COOLER CUSHION
Installation Instructions for the 150 & 170 Super Sport
Issue Date
05/07/2010
Rev:C
PROCEDURE NO.
AI-MS-013
8.1.4. Using the drill with Phillips head bit, insert a snap
receiver into each of the holes drilled in the
previous step.
8.1.5. Secure the cushion to the cooler lid by attaching
each snap on the four corners of the cushion.
Cooler Cushion Installation Is Complete
Page 3 of 3
/