ACCESSORY INSTALLATION
INSTRUCTIONS
COOLER CUSHION
Installation Instructions for the 130 Super Sport
Issue Date
07/08/2009
REV: A
PROCEDURE NO. AI-MS-021
1. PURPOSE
Provide step-by-step procedure for the cooler
cushion installation.
2. SCOPE
This procedure is limited to the cooler cushion
installation on the 130 Super Sport.
3. DEFINITION
3.1. Not Applicable
4. RESPONSIBILITY
4.1. Not Applicable
5. TOOLS/EQUIPMENT REQUIRED
5.1. Phillips Head screwdriver
5.2. Pencil
5.3. Hardware (supplied)
6. SAFETY
6.1. Safety glasses or goggles are
recommended.
7. FORMS
7.1. Not applicable
CONTENTS OF KIT PART #
1- COOLER CUSHION...................................... 1972025
2- HARDWARE PKG............901BWCOOLERCUSHION
Page 1 of 3
ACCESSORY INSTALLATION
INSTRUCTIONS
COOLER CUSHION
Installation Instructions for the 130 Super Sport
Issue Date
07/08/2009
REV: A
PROCEDURE NO. AI-MS-021
8. PROCEDURE
8.1. Place the cushion on the cooler.
8.2. Using the pencil, make a mark on the cooler lid
corresponding (just under) to each snap (2 in front &
2 in back) attached to the cushion.
8.3.
Using the Phillip head screwdriver, insert a snap
(supplied) at each of the four positions marked in
the previous step.
Note: DO NOT over tighten. Doing so may strip
the plastic.
Page 2 of 3
ACCESSORY INSTALLATION
INSTRUCTIONS
COOLER CUSHION
Installation Instructions for the 130 Super Sport
Issue Date
07/08/2009
REV: A
PROCEDURE NO. AI-MS-021
8.4.
Secure the cushion to the cooler by attaching the four
tabs to the snaps installed in the previous step.
Cooler cushion Installation Is Complete
Page 3 of 3
/