2. BLOTZ
  3. B28-SF-212

BLOTZ B28-SF-212 Assembly Instructions

  • Hello! I'm a chat assistant who has reviewed the instructions for the 28mm Computer Console, model B28-SF-212. I understand the assembly process, including the required tools and techniques. I am ready to answer any questions you may have about the model or the assembly process.
  • What kind of glue is required for assembly?
    What tool is needed to remove sections from the sprue?
    What can be used to hold pieces in place while the glue dries?
28mm Computer Console
B28-SF-212
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and
remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
Computer Console (B28-SF-212)
To start with remove the base and the front, rear
and support of the central console from the
sprue.
Glue them into place as shown above.
Then glue the two sets of legs into place. Note
the slope on the top of these should be lowest at
the front.
Glue the horizontal consoles to the side sections. The
longest edge of the horizontal console should be at
the lowest edge of the upright.
Glue these into position as shown.
Glue the top of the console into place.
Then add the raised console.
An excample of the painted console.
/