2. Regency
  3. MCTRCT4824GY
MCTRCT4824GY

Regency MCTRCT4824GY, MCTRCT4824MH, MCTRCT4824MW Installation guide

  • Hello! I am an AI chatbot trained to assist you with the Regency MCTRCT4824GY Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
A
B C
D
E
F
G
A. Table Top
B. Rod
C. Cylinder
D. Screws(16)
E. Feet(4)
F. Spider
G. T-base
Cain Rectangle T-Base Legs
Step 1: Screw 4 Feet(E) into
T-base leg ends (G).
Step 2: On the Rod(B) remove the nut
from the bolt, set the nut aside.
Step 3: Insert the Rod(B) through the hole
in the Spider(F).
The permanent
nut should be
on the top side
of the Spider(F).
Step 4: Next place the Cylinder(C) over the
exposed Rod(B).
Step 5A: Place the exposed end of the Rod(B)
through the hole in the T-Base(G). Now, replace
the nut onto the rod and tighten. Make sure the
front and back arms of the spider are angled in
the same direction as the T-Base arms.
Step 5B: Repeat Steps 1-5A for second T-Leg.
The product
should now
look like the
example to the
right.
Organize your parts. You will need a phillips head screw driver, pencil and measuring tape, drill(optional).
Two people are required for assembly.
IMPORTANT NOTICE
Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the parts from being scratched.
Check to be sure that you have a ll parts and hardware.
Remove all wrapping materials, including staples & packing straps before you start to assemble.
Do not tighten all screws/bolts until completely assembled.
Keep all hardware parts out of reach of children.
Any problems or questions please call Regency Office Furniture at 1-866-816-9822
Step 7: On a clean flat surface, turn Table
Top(A) upside down. Draw a horizontal lines
across the table bottom that is equidistant
from front to back of the table top.
Step 9: Attach T-Legs to Table Top(A) using 8 Screws(D) per T-Leg. Flip Table over when complete.
Step 8: Place each T-Leg equidistant from
the Left and Right edges of the table top at
user’s desired distance.
Step 6: Prepare your Template (INCLUDED) by adhereing both template pages to one another on the dashed line.
/