Victor M2524S Installation guide

1. Remove battery cover. Insert 4 “AA” batteries.

Replace the battery cover.

2. Open the lid on the electronic mouse trap.

3. Bait the trap using the bait trough provided.

The bait trough is located on the back wall of

the trap. Apply a small amount of peanut butter

or anything high in protein like chocolate,

hazelnut spread, etc. Be sure to use a Q-tip,

toothpick or another tool to bait so your scent

is not transferred onto the trap. Close the lid on

the electronic mouse trap.

4. Place the trap where you have seen signs of

rodent activity or along the wall where rodents

primarily travel. The trap should be placed

lengthwise against the wall with the entrance

hole nearest the wall.

5. Turn on the trap – a green light will blink once

showing the trap is working properly.

6. A blinking green light will indicate a kill.

Dispose of the dead rodent, bait, place and

reset for continued rodent control.

Electronic Mouse Trap

Instructions

2 31

4 5

www.victorpest.com