1. Remove the battery cover. Insert 4 “AA”
batteries. Replace the battery cover.
2. Bait the trap through the entrance placing a
small amount of peanut butter, bacon, dry pet
food, nuts, etc. on or along the back wall. Be
sure to use a Q-tip, toothpick or another tool
to bait so your scent is not transferred onto
the trap.
3. Place the trap where you have seen signs of
rodent activity or along the wall where rodents
primarily travel. The trap should be placed
lengthwise against the wall with the entrance
hole nearest the wall.
4. Turn on the trap – a red light will blink once
showing the trap is working properly.
5. A blinking red light will indicate a kill. Dispose
of the dead rodent, bait, reset and place for
continued rodent control.
Electronic Rat Trap
Instructions
1
5
2 3
4
www.victorpest.com
Classic
