Rat Zapper RZU001-4 Installation guide

1. P

lace a small amount of bait such as peanut

butter on the back wall of the unit, away from

the metal plates on the floor of the trap. Be

sure to use a cotton swab, toothpick or

another tool to bait so your scent is not

transferred to the trap.

2. Remove the battery cover. Insert 4 new "D"

batteries. Replace the battery cover.

3. Place the trap on a flat surface against a wall

where you have seen signs of rodent activity.

The trap should be placed lengthwise with the

entrance nearest to the wall.

4. Turn the main switch ON. A green light will

blink once to indicate that the batteries are

good and the trap is working properly.

5. When a rodent is caught, the red light will

flash once every 7 seconds. Turn the unit

OFF, remove the batteries and dispose of the

rodent. Bait the trap, insert the batteries and

turn the main switch ON. A rapid red flash

indicates that the batteries no longer have

enough power to kill a rodent. Replace with 4

new batteries. The old batteries may still be

used for other products that take "D"

batteries.

Electronic Rat Trap

Instructions

2 3

www.victorpest.com

Ultra