Victor M240 Installation guide

1. Remove the battery cover. Insert 4 “C”

batteries. Replace the battery cover.

2. Bait the trap through the hole in the back wall

using a small amount of peanut butter, bacon,

dry pet food, nuts, etc. Be sure to use a Q-tip,

toothpick or another tool to bait so your scent

is not transferred onto the trap.

3. Place the trap where you have seen signs of

rodent activity or along the wall where rodents

primarily travel. The trap should be placed

lengthwise against the wall with the entrance

hole nearest the wall.

4. Turn on the trap – a green light will blink once

showing the trap is working properly.

5. A blinking green light will indicate a kill.

Dispose of the dead rodent, bait, reset and

place for continued rodent control.

Electronic Rat Trap

Instructions

2 3

www.victorpest.com