Victor M250PRO Installation guide

1. Remove battery cover. Insert 4 “AA” batteries.

Replace the battery cover.

2. Open the lid on the electronic mouse trap.

3. Bait the trap using the bait trough provided.

The bait trough is located on the back

wall of the trap. Apply a small amount of

peanut butter or anything high in protein like

chocolate, hazelnut spread, etc. Be sure to

use gloves, a Q-tip, toothpick or another tool

to bait so your scent is not transferred onto

the trap. Close the lid.

4. Place the trap where you have seen signs of

rodent activity or along the wall where rodents

primarily travel. The trap should be placed

lengthwise against the wall with the entrance

hole nearest the wall.

5. Turn on the trap - a green light will blink once

showing the trap is working properly.

6. A blinking green light will indicate a kill.

Dispose of the dead rodent, bait, place and

reset for continued rodent control.

Electronic Mouse Trap PRO

Instructions

www.victorpest.com

Download PDF