Page is loading ...
1. Remove battery cover. Unwrap and insert the
4 “C” batteries provided. Replace the battery
cover.
2. Open the top of the Multi-Kill Electronic
Mouse Trap.
3. Bait the trap using the bait trough provided. The
bait trough is located on the back wall of the
trap. Apply a small amount of peanut butter or
anything high in protein like chocolate, hazelnut
spread, etc. Be sure to use a Q-tip, toothpick
or another tool to bait so your scent is not
transferred onto the trap. Close the lid on the
electronic mouse trap.
4. Place the trap where you have seen signs of
rodent activity or along the wall where rodents
primarily travel. The trap should be placed
lengthwise against the wall with the entrance
hole nearest the wall.
5. Turn on the trap – a green light will blink once
showing the trap is working properly.
6. A blinking green light will indicate a kill. Dispose
of the dead rodent, bait, place and reset for
continued rodent control.
Multi-Kill
™
Electronic Mouse Trap
Instructions
1
4 5 6
2 3
www.victorpest.com
/
