2. AVFI
  3. CR2-WM Credenza

AVFI CR2-WM Credenza Assembly Guide

  • Hello! I've reviewed the assembly instructions for the AVFI CR2-WM Wall Mounted Credenza. This document outlines steps for mounting the credenza, which can hold up to 6U of rack equipment and a sound bar. I can help answer your questions about the installation process, required parts, or other features detailed in this document.
  • How many people are required for assembly?
    What type of wall can the credenza be mounted on?
    What is the maximum depth of the equipment that can be installed?
Hardware
Included in HW bag.
Tools Required
Not Included
Washer
x4
LAG
Shield
x4
HEX
Bolt
x4
Hardware Bag
Socket set
LAG Bolt
x4
Toggle
Anchor
x4
Legs
x3
Stud Finder
If Drywall
DrillDrill bit set
CR2-WM Assembly Instructions
www.video-furn.com 190 Don Hillock Drive|Aurora|Ontario|L4G 0G9
1.877.834.3876
CR2-WM
Credenza
Parts
Included
Thank you for purchasing Wall mounted Credenza CR2-WM
This Credenza allows for mounting up to 6U (2x 3U) of rack equipment and a sound bar up against a wall.
If you cannot understand these instructions or are concerned about safety of the installation
Contact a qualified contractor or contact AVFI at 1-877-834-3876.
Read through entire instructions before beginning assembly.
This assembly will require a minimum of 2 people.
Drywall/Stud wall
Locate studs using stud finder and mark
Approx. 23” above floor height. Follow
Masonry step below to line up studs.
Step 1
Unpack and
Lift off front
panels.
Discard
Shipping
Brace.
Step 2
Attach Legs
Step 3
Locate mounting points
And prepare Wall
Masonry wall
Place CR2-WM against wall at desired location
And mark 4 hole locations through holes at
Back of unit.
Place over an outlet
If possible.
Baseboard trim
May need to cut away.
Leave Clearance for door.
Twist on legs x3
Assembly Instructions
www.video-furn.com 190 Don Hillock Drive|Aurora|Ontario|L4G 0G9
1.877.834.3876
Lift off Panels
Step 3 Continued
Attach Fasteners to wall
Drywall/steel stud Wood Stud Masonry
1 / 4 “Drill 1 / 2 “ Drill
Lag Shield
Assembly Instructions
www.video-furn.com 190 Don Hillock Drive|Aurora|Ontario|L4G 0G9
1.877.834.3876
Step 4
Install Equipment and Sound bar
Step 5
Reinstall Panels.
Finished
Thanks for Purchasing AVFI.
Have a great day.
Side doors
For access to
System On/Off
Up to 4x 120mm
Fans can be
Added underneath.
Side mount 3U
Per Bay
Max depth 25”
Shelf is adjustable w pins
Can be removed If Sound bar is Tall.
Assembly Instructions
www.video-furn.com 190 Don Hillock Drive|Aurora|Ontario|L4G 0G9
1.877.834.3876
/