AVFI LFT7000WM Assembly Instructions Manual

Category
Wall & ceiling mounts accessories
Type
Assembly Instructions Manual
VFI
Assembly Instructions
LFT7000WM Wall mount lift stand
Thank you for purchasing AVFI’s LFT7000WM lift stand.
This stand is designed for TV setups totaling up to 280lbs.
Confirm all hardware is included before you begin assembly.
Read these instructions start to finish before beginning installation.
Note: If you cannot understand these instructions or are concerned about safety
of the installation contact a qualified contractor or contact AVFI at 1-877-834-3876.
Supplied Parts
Supplied Hardware (additional to hardware bags)
1
www.video-furn.com
190 Don Hillock Drive |Aurora |Ontario|L4G 0G9 | 1.877.834.3876
Tower
Box 1
Not all hardware supplied will be used.
TV Hardware bag
x2 if dual mount
Tools required
Wrench or Socket set
Keys
(2)
LFT-WM
Hardware bag
TV Brackets
S (shown)/XL/D
+ Tube.
found inside Tower.
Allen Keys found
In hardware bag
VF
I
Assembly Instructions
LFT7000WM Wall mount lift stand
www.video-furn.com
190 Don Hillock Drive |Aurora |Ontario|L4G 0G9 | 1.877.834.3876
1
2
2
Unlock and remove front panels.
Remove brackets and hardware bags from
inside.
Find and mark studs if stud wall.
Preferably over outlet.
Position Tower with holes Lined up over stud
centers.
Level unit using adjustable feet.
Mark hole locations.
TV Brackets
S (shown)/XL/D
+ Tube.
found inside unit.
VF
I
Assembly Instructions
LFT7000WM Wall mount lift stand
www.video-furn.com
190 Don Hillock Drive |Aurora |Ontario|L4G 0G9 | 1.877.834.3876
3
3
Drill 3” deep Holes
4
Install lag bolts.
VF
I
Assembly Instructions
4
www.video-furn.com
190 Don Hillock Drive |Aurora |Ontario|L4G 0G9 | 1.877.834.3876
LFT7000WM Wall mount lift stand
Install rack equipment and run wiring.
Additional rack rails can be added.
(3U rack rail part# RR3 ) 10-32 threads
Plug in and test run unit up and down.
Then install and lock front top panel.
6
5
Insert Tube into carriage openings.
Center and tighten using M8 bolts.
(Single version shown)
7
VF
I
Assembly Instructions
LFT7000WM Wall mount lift stand
www.video-furn.com
190 Don Hillock Drive |Aurora |Ontario|L4G 0G9 | 1.877.834.3876
8
5
Install TV brackets onto back of TV.
Remove top bolts if present
X
Lower to bottom position
To hang TV.
See step 10.1 before
proceeding.
Hang TV onto
tube.
9
VF
I
Assembly Instructions
LFT7000WM Wall mount lift stand
www.video-furn.com
190 Don Hillock Drive |Aurora |Ontario|L4G 0G9 | 1.877.834.3876
10
6
Lock TV onto tube.
VF
I
Assembly Instructions
LFT7000WM Wall mount lift stand
www.video-furn.com
190 Don Hillock Drive |Aurora |Ontario|L4G 0G9 | 1.877.834.3876
11
7
Confirm all cable clearances when moving TV up
and down. Reinstall and lock front panel.
End of Instructions.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7

AVFI LFT7000WM Assembly Instructions Manual

Category
Wall & ceiling mounts accessories
Type
Assembly Instructions Manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI