BLOTZ B10_CS_100 Assembly Instructions

10mm Car Park

B10-CS-100

Please read these instructions fully before starting construction.

PVA or equivalent glue will be required to stick sections together.

Sand paper can be used to gently clean any joints.

A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due

care and remember to cut away from yourself at all times.

During the construction of this model, you may find it convenient to use pegs / elastic bands to hold

pieces in place while you allow glue to dry.

Lower Level

Start by removing the sections shown above from

the sprue.

Glue the entrance and side wall into position using the

holes/lugs provided.

Then glue the rear wall and other side into place.

Leave to dry.

Upper Level

Each of the four pillars are formed by the two

pieces shown on the left. Slide them together to

form a cross as shown on the right.

Glue each pillar into position using the lugs/holes

provided.

Take the ramp side and insert it (as shown) so

that the floor fits into the slot. It will then be

possible to move the piece fully into position.

Add the end wall and ramp.

Then glue the outer wall into position as shown.

Repeat this for the ramp at the other end of the

level.

Finally glue the two long walls into place.

The completed car park

This manual is also suitable for

Download PDF