H3C SecPath M9000 NSQM1MBFEA0 Quick start guide

Brand: H3C

Model: SecPath M9000 NSQM1MBFEA0

Type: Quick start guide

资料版本: 6PW102-20180530

BOM: 3123A1N2

H3C SecPath M9000 NSQM1MBFEA0 interface

module

1 Identifier

The module identifier NSQM1MBFEA0 is in the upper right corner of the front panel.

2 Introduction

The NSQM1MBFEA0 interface module is developed for H3C SecPath M9000 gateways. It provides

two subcard slots. By using the interface module with M9000 high-performance service modules, the

M9000 gateway is capable of providing security for 100G networks.

3 Specifications

Figure 1 Front panel

(1) Captive screw (2) Ejector lever

(3) Subcard slot 1 (4) Subcard slot 2

Table 1 Module specifications

Item Specifications

Dimensions (H × W × D) 40 × 399 × 354 mm (1.57 × 15.71 × 13.93 in)

SDRAM (DDR3) 2 GB

Power consumption 41W to 62W

Net weight 2.90 kg (6.39 lb), including the ejector lever

Hot swapping Supported

Ambient temperature

• Operating: 0°C to 40°C (32°F to 104°F)

• Storage: –40°C to +70°C (–40°F to +158°F)

Ambient humidity

• Operating: 5% RH to 95% RH, noncondensing

• Storage: 5% RH to 95% RH, noncondensing

Compatible device models

• M9006 gateway

• M9010 gateway

• M9014 gateway

资料版本: 6PW102-20180530

BOM: 3123A1N2

4 Installing or removing the module

CAUTION:

• Wear a reliably-grounded ESD wrist strap or ESD gloves before you install or remove the

module.

• Do not touch the components on the module.

4.1

Installing the module

1. Face the front panel of the device and remove the filler panel from the target slot.

This example uses slot 2 on an M9006 gateway.

2. Place the module on a flat surface with the surface-mounted components facing up. Open the

ejector levers, and then gently push the module into the slot along the guide rails.

3. Close the ejector levers and ensure that the module makes close contact with the backplane.

4. Use a Phillips screwdriver to fasten the captive screws on the module.

Figure 2 Installing the module

4.2

Removing the module

1. Use a Phillips screwdriver to loosen the captive screws on the module until all pressure is

released.

2. Open the ejector levers to disengage the module connectors from the backplane, and then pull

the module out of the slot along the guide rails.

3. Place the module on an anti-static workbench or in an anti-static bag with the surface-mounted

components facing up.

4. If you are not to install a new module, install a filler panel in the slot to prevent dust and ensure

good ventilation in the chassis.

The information in this document is subject to change without notice.

H3C SecPath M9000 NSQM1MBFEA0 Quick start guide

H3C SecPath M9000 NSQM1MBFEA0 Quick start guide

H3C SecPath M9000 NSQM1MBFEA0 Quick start guide

Related papers

Other documents