H3C SecPath M9000-AI NSQM5MBSHA1 User manual

Brand: H3C

Model: SecPath M9000-AI NSQM5MBSHA1

Type: User manual

Manual version: APW100-20190606 BOM: 3123A1T7

H3C SecPath M9000-AI NSQM5MBSHA1 interface

switch module

1 Identifier

The module identifier NSQM5MBSHA1 is in the upper right corner of the front panel.

2 About the module

The NSQM5MBSHA1 interface switch module is developed for H3C SecPath M9000-AI multiservice

security gateways. It provides two subcard slots. Working in conjunction with an M9000-AI interface

switch module, it meets 100G network requirements and can greatly enhance the security capability

of the device.

3 Specifications

Figure 1 Front panel

(1) Captive screw (2) Subcard slot 1

(3) Subcard slot 2 (4) Ejector lever

Table 1 Module specifications

Item Specifications

Dimensions (H × W × D) 50 × 432.6 × 521.3 mm (1.97 × 17.03 × 20.52 in)

SDRAM (DDR3) 2 GB

Power consumption 79 W to 89 W

Net weight 5.9 kg (13.01 lb)

Hot swapping Supported

Ambient temperature

• Operating: 0°C to 45°C (32°F to 113°F)

• Storage: –40°C to +70°C (–40°F to +158°F)

Ambient humidity 5% RH to 95% RH, noncondensing

Compatible device models

• M9000-AI-E8 multiservice security gateway

• M9000-AI-E16 multiservice security gateway

Compatible interface

modules

• NS-C300-CGQ2TG16A1

• NS-C300-QG4TG16A1

• NS-C300-TG24A1

• NS-C600-CGQ6A1

Manual version: APW100-20190606 BOM: 3123A1T7

4 Installing or removing the module

4.1

Installing the module

1. Face the front panel of the device and remove the filler panel from the target slot.

2. Pivot the ejector levers down to the horizontal position, fully open the ejector levers, and then

gently push the module into the slot along the guide rails.

3. Pivot the ejector levers to the left until the module makes close contact with the backplane.

4. Use a Phillips screwdriver to fasten the captive screws on the module.

5. Close the ejector levers on the module.

Figure 2 Installing the module

4.2

Removing the module

1. Pivot the ejector levers down to the horizontal position.

2. Use a Phillips screwdriver to loosen the captive screws on the module until all pressure is

released.

3. Simultaneously open the ejector levers on the module to separate the module from the

backplane, and then pull the module slowly out of the slot along the guide rails.

4. Place the module on an anti-static workbench or put it in an anti-static bag.

5. If you are not to install a new module, install a filler panel in the slot to prevent dust and ensure

good ventilation.

The information in this document is subject to change without notice.

H3C SecPath M9000-AI NSQM5MBSHA1 User manual

H3C SecPath M9000-AI NSQM5MBSHA1 User manual

H3C SecPath M9000-AI NSQM5MBSHA1 User manual

Related papers

Other documents