Energy Suspension 3.3152G3.3152G, 3.3153G3.3153G Operating instructions

  • Hello! I am an AI chatbot trained to assist you with the Energy Suspension 3.3152G3.3152G Operating instructions. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Set # 3-3152 & Set # 3-3153
17088
3/26/97 KN
Updated 18/JAN/02 BRH
The thrust washers are designed to prevent the
control arm from walking side-to-side by accepting
side load pressure created during hard cornering.
Most kits contain more than one part #. It is very
important to install them at the correct location.
See illustration
Must use existing outer metal shells.
Lubricate sleeves, bushings and I.D. of shells with
supplied grease.
Install bushings in shell, then install sleeve in
bushing.
Thrust washers are installed over shell area
opposite of flange
3147-Bushing
3150-Thrust washer
3147-Bushing
3150-Thrust washer
3147-Bushing
3150-Thrust washer
3199-With new shell
3204-Thrust washer
Bushing outer
metal shell
Thrust washer
install from this
side with pt #
facing outward
Control arm
Bushing
Flange
1131 VIA CALLEJON, SAN CLEMENTE, CA 92673
R
Updated 13/DEC/01 BRH
2002 Energy Suspension. All rights reserved.2002 Energy Suspension. All rights reserved.
CC
May not be reproduced, in any form, or by any means,
without the written consent of Energy Suspension.
May not be reproduced, in any form, or by any means,
without the written consent of Energy Suspension.
Set # 3-3152 & Set # 3-3153
17088
3/26/97 KN
Updated 18/JAN/02 BRH
The thrust washers are designed to prevent the
control arm from walking side-to-side by accepting
side load pressure created during hard cornering.
Most kits contain more than one part #. It is very
important to install them at the correct location.
See illustration
Must use existing outer metal shells.
Lubricate sleeves, bushings and I.D. of shells with
supplied grease.
Install bushings in shell, then install sleeve in
bushing.
Thrust washers are installed over shell area
opposite of flange
3147-Bushing
3150-Thrust washer
3147-Bushing
3150-Thrust washer
3147-Bushing
3150-Thrust washer
3199-With new shell
3204-Thrust washer
Bushing outer
metal shell
Thrust washer
install from this
side with pt #
facing outward
Control arm
Bushing
Flange
1131 VIA CALLEJON, SAN CLEMENTE, CA 92673
R
Updated 13/DEC/01 BRH
2002 Energy Suspension. All rights reserved.2002 Energy Suspension. All rights reserved.
CC
May not be reproduced, in any form, or by any means,
without the written consent of Energy Suspension.
May not be reproduced, in any form, or by any means,
without the written consent of Energy Suspension.
/