Vicoustic Flat Panel VMT User manual

Type
User manual
EN
Flat Panel VMT
Installation Manual
EN
Not Included
Level
MATERIAL NEEDED
Included
Available formats
Flat Panel VMT
Measuring Tape Box Cutter
1190x595mm
595x595mm
Velcro Stripes
Glue
EN
Partial wall installation
12
1
1
2
Velcro Stripes
34
1
2
3
2
1
3
4
1
EN
1
2Based on the smallest height, calculate if it is necessary to cut
one of the panels to ll the entire wall height. Check for continuity
between panels before cutting.
Measure wall height in both sides. Take the smallest height.
?
?
1
Full wall installation
B
EN
3
4Start the installation from the bottom-right side (If cuted panels
are going to be used it is recommended to start with these). Check if
panels are leveled before proceding to next row.
Glue the Velcro tape in the wall. It is recommended to use
2 stripes of Velcro per panel (included). You can also glue the panels
directly to the wall with Flexi Glue Ultra
1
BB
BB
2 1
EN
5
6
Install the remaining panels.
VMT boards can be installed vertically or horizontally, depending on the
pattern and desired orientation.
EN
For the installation of Flat Panel VMT on the ceiling, we recommend
using Flexi Glue Ultra.
!
Do not apply Flat Panel VMT behind radiators or too close to a heat
source.
© Vicoustic, 2021 | V6
No parts of this document might be copied and/or published without written consent of Vicoustic.
Main Oce, R&D & Logistics
Avenida do Pólo 3, Nº 159, Carvalhosa
4590-137 Paços de Ferreira, Portugal
Oce
Rua Quinta do Bom Retiro Nº 16, Armazém 9
2820-690 Charneca da Caparica, Portugal
T (+351) 212 964 100
Info and Sales
E sales@vicoustic.com
www.vicoustic.com
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8

Vicoustic Flat Panel VMT User manual

Type
User manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI