28mm Shop #2
B28-CS-003
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
Ground Floor
First attach the side and rear walls to the base
with any etched details facing outwards. The side
walls are interchangeable so you can choose
which side you have the door on.
The front wall of the shop is formed from the pieces
shown above.
Attach the front wall pieces to the building as
shown above.
Use the ‘S’ pieces to lock the front wall into position.
(Their sprue points face into the shop)
Attach the outer skin to the side and rear walls.
The outer skin of the side walls fit flush to them,
the rear wall (which is supplied in 2 pieces)
overlaps the sides.
These pieces form the outer skin of the front wall.
Starting with the doorway (and working
outwards), attach the outer skin to the front wall.
Glue the drain pipe into place (with the kink at the
top).
Middle Floor
NB: The “front” of the floor of this level is marked
with two V’s.
Attach the walls to the base, with any etched detail
facing outwards. The lugs on the side and rear walls
are designed to extend below the level of the floor as
they help the levels lock together. The side walls are
interchangeable.
Attach the outer skin to the walls. The rear walls
outer skin is supplied in 2 pieces.
Glue the drainpipe into place.
Roof
NB: The “front” of the floor of this level is marked
with two V’s.
Attach the walls to the base. The lugs on the side and
rear walls are designed to extend below the level of
the floor as they help the levels lock together.
Attach the outer skin to the walls.
Glue the wall caps into place.
Attach the top of the drainpipe.
Glue the skylight together as shown.
-
1
-
2
-
3
BLOTZ B28-CS-003 Assembly Instructions
- Type
- Assembly Instructions
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
BLOTZ B10_ME_001 Assembly Instructions
-
BLOTZ B28-ME-001 Assembly Instructions
-
BLOTZ B10_ME_004 Assembly Instructions
-
BLOTZ B10-ME-005 Assembly Instructions
-
BLOTZ B10-CS-262 Assembly Instructions
-
BLOTZ B10-ME-003 Assembly Instructions
-
BLOTZ B10-CS-310 Assembly Instructions
-
BLOTZ B28-ME-005 Assembly Instructions
-
BLOTZ B28-CS-002 Assembly Instructions
-
BLOTZ B15-CS-006 Assembly Instructions
