2. BLOTZ
  3. B10-CS-262

BLOTZ B10-CS-262 Assembly Instructions

  • Hello! I've reviewed the instructions for the BLOTZ Tower Block B10-CS-262. This document provides guidance for assembling the 10mm 3x3 Tower Block Middle model, including how to attach the walls, support lugs, and sun-screen strips. I am ready to answer your questions about this model's construction.
  • What type of glue is needed?
    What is needed to clean the joints?
    What kind of knife to remove sections from the sprue?
10mm 3x3 Tower Block Middle
B10-CS-262
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due
care and remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold
pieces in place while you allow glue to dry.
Middle Section
Take the four walls and base from the sprue.
Glue the walls to the base as shown, aligning them
using the holes / lugs provided.
Flip the whole thing upside down and glue the
support lugs into place.
Take the twelve sun-screen strips from the sprue and
attach three to each side of the building as shown
above.
/