BLOTZ B28-ME-005 Assembly Instructions

Type
Assembly Instructions
28mm Middle Eastern Building #5
B28-ME-005
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and
remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
Remove the four main walls from the sprue.
Glue them together as shown to form two separate
sections.
Attach the sections together and glue them to
the base.
Take the remaining walls
..and glue them into position.
Take the two pillars.
..and glue them into place just inside the
opening in the wall.
Take the roof supports as shown above.
Glue them into place so that they extend
through the wall (see pic).
Place (do not glue) the roof into position, then glue the
trapdoor to it.
The completed building.
  • Page 1 1
  • Page 2 2

BLOTZ B28-ME-005 Assembly Instructions

Type
Assembly Instructions

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI