2. BLOTZ
  3. B20_ME_212

BLOTZ B20_ME_212, B20-ME-212 Assembly Instructions

  • Hello! I've reviewed the instructions for the BLOTZ Damaged Wall model. This document provides a step-by-step guide on how to assemble the 20mm ancient city wall sections, including connecting the supports, adding the rear and front walls, and using rubble pieces to complete it. I am here to assist with any questions you might have about building your model.
  • What type of glue is required for assembly?
    Is any special tool needed for the assembly?
    What is the recommended method for holding pieces together while the glue dries?
20mm Ancient City Walls – Damaged Wall
B20-ME-212
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
Remove the pieces shown above from the sprue.
Glue the connectors to the main supports, then
attach the rear wall before gluing the whole
assembly to the base.
Take the end braces.
Glue them to the model (see pic).
Attach the walkway.
The “rubble” pieces (in order from left to right)
Glue them to the model – leaving the smallest off
for the moment.
Add the lower front wall.
Attach the smallest rubble strip.
Add the top wall and long strip.
Remove the pieces shown above from the sprue.
Glue the connectors to the main supports, then
attach the rear wall before gluing the whole
assembly to the base.
Take the end braces.
Glue them to the model along with the walkway
piece (see pic).
Add the rubble pieces.
Finish off by adding the front wall pieces and final
rubble section.
/