2. BLOTZ
  3. B28-SF-227

BLOTZ B28-SF-227 Assembly Instructions

  • Hello, I'm your chat assistant. I have reviewed the instructions for the BLOTZ Walkway B28-SF-227. This document guides you through the assembly process step by step, detailing how to join the various parts together. The model features an open design, including barricades, brackets and a rear piece. I'm here to answer any questions you might have about the building steps or the features.
  • What type of glue is required?
    Is any special tool required to build the model?
    What should I do if I find some rough edges on the joints?
28mm Walkway – Open
B28-SF-227
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and
remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in
place while you allow glue to dry.
Take the two pieces shown above from the sprue.
Glue the one on the left to the back of the one on
the right.
Take the barricade section…
..and glue it into position (see pic).
Take the walkway and support brackets from the
sprue.
Glue the walkway into place, then add the brackets,
attaching the “higher” end to the lugs.
Take the rear piece.
Glue this into place with the etched detail facing
into the model. Attach the “lower” end of the
brackets to the lugs.
Glue the model to the base.
Take the “H” piece.
Glue it to the rear section as shown above.
Take the armour plates.
Glue them into position.
The finished walkway section.
/