2. BLOTZ
  3. B20_ME_210

BLOTZ B20_ME_210, B20-ME-210, B28-ME-210 Assembly Instructions

  • Hello! I've reviewed the instructions for the BLOTZ City Walls B20-ME-210 and B28-ME-210 models. These instructions detail how to assemble the internal corner of the city wall model using provided parts. The steps include gluing connectors, attaching supports, and adding the front wall and walkway sections. I'm ready to answer your questions about the assembly process or any features of the model.
  • What type of glue is required?
    What tool is recommended to remove parts from sprue?
    Can sandpaper be used during assembly?
    Are the 20mm and 28mm versions assembled the same way?
20mm / 28mm Ancient City Walls – Internal Corner (90 deg)
B20-ME-210 / B28-ME-210
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
The images here show the 20mm version of this kit, but the 28mm version is constructed in exactly the same way.
Remove the pieces shown above from the sprue.
Glue the connectors to the main supports – the
wider connectors being the ones closest together.
Take the base and rear wall.
Glue the supports to the rear wall, then attach the
whole assembly to the base (see pic).
Take the secondary supports.
Add them to the model.
Add the walkway section, gently slotting each lug
into the corresponding hole.
The front wall pieces.
Add the front wall sections.
Attach the long strip.
/