BLOTZ B20-ME-212 Assembly Instructions

Brand
BLOTZ
Model
B20-ME-212
Type
Assembly Instructions

This manual is also suitable for

20mm Ancient City Walls – Damaged Wall
B20-ME-212
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
Remove the pieces shown above from the sprue.
Glue the connectors to the main supports, then
attach the rear wall before gluing the whole
assembly to the base.
Take the end braces.
Glue them to the model (see pic).
Attach the walkway.
The “rubble” pieces (in order from left to right)
Glue them to the model – leaving the smallest off
for the moment.
Add the lower front wall.
Attach the smallest rubble strip.
Add the top wall and long strip.
Remove the pieces shown above from the sprue.
Glue the connectors to the main supports, then
attach the rear wall before gluing the whole
assembly to the base.
Take the end braces.
Glue them to the model along with the walkway
piece (see pic).
Add the rubble pieces.
Finish off by adding the front wall pieces and final
rubble section.
  • Page 1 1
  • Page 2 2

BLOTZ B20-ME-212 Assembly Instructions

Brand
BLOTZ
Model
B20-ME-212
Type
Assembly Instructions
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers