BLOTZ B28-ME-111 Assembly Instructions

  • Hello! I've reviewed the provided instructions for the BLOTZ Desert Fort In-line Tower model. This document provides detailed steps for assembling the laser-cut parts into a 28mm scale desert fort including angled supports, a walkway, and tower sides. I'm ready to answer your questions about the assembly process or any other details regarding this model.
  • What kind of glue is required?
    What tool is needed to remove pieces from the sprue?
    What should be used to hold pieces together while drying?
28mm Desert Fort In-line Tower
B28-ME-111
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
Remove the pieces shown above from the sprue.
Glue them together as shown above Note the
angled supports have an arrow on them which
should point upwards.
Add the walkway piece, moving around the model
gently easing each lug into the corresponding
hole.
Take the tower sides and roof.
Attach them to the model as shown above.
Add the other two tower sides.
Attach the front wall piece on each side of the
tower.
The finished model.
/