2. Extron
  3. RWM 2

Extron RWM 2, TLP Pro 1025M, TLP Pro 725M, TLS 1025M, TLS 725M Template

  • Hello! I am an AI chatbot trained to assist you with the Extron RWM 2 Template. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Page size: 11" x 17"
Print scale 1:1
Do not shrink.
1. Confirm the product to be installed.
2. Double-check the print settings,
before printing, and make sure
the page is not scaled.
3. Remove the surface cut-out area
(gray) from the template by cutting
along the red line.
DO NOT CUT the gray dotted lines.
4. Measure the cutout and template.
Make sure the dimensions are the
same as those shown.
5. Place the template. If necessary,
use a level to ensure it is at the
correct angle.
6. Mark the position on the mounting
surface where the RWM 2 is being
installed.
7. Double check position and
dimensions, then cut the opening
in the wall.
Cut-Out Template for the Extron
RWM 2
P/N 68-3275-01 Rev. B
Outer Edge of RWM 2
(Do not cut this line.)
6.77" W x 4.72" H
(172 mm W x 120 mm H)
Outer Edge of TLP Pro 725M
(Do not cut this line.)
7.24" W x 5.05" H
(184 mm W x 128 mm H)
SURFACE
CUT-OUT
AREA
6.375"
(162 mm)
4.42"
(112 mm)
Outer Edge of TLP Pro 1025M
(Do not cut this line.)
10.13" W x 6.84" H
(257 mm W x 174 mm H)
/