2. Extron
  3. TLS 525M
TLS 525M

Extron TLS 525M, TLC Pro 526M, TLP Pro 525M Template

  • Hello! I am an AI chatbot trained to assist you with the Extron TLS 525M Template. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Cut-out Template for the Extron
TLP Pro 525M, TLS 525M,
and TLC Pro 526M Series
1. Confirm the product to be installed.
2. Before printing, double-check the print
settings and make sure the page is not
scaled.
3. Cut the red line and remove the surface
cut-out area (gray) from the template.
4. Measure the gray dotted lines to make
sure they have the dimensions shown.
5. Place the template. Use a level to ensure
it is at the correct angle and make sure
that there is enough room for the
touchpanel.
6. Mark the position on the mounting
surface where the touchpanel is being
installed.
7. Double-check dimensions and position,
then cut the opening.
P/N 68-3207-01 Rev. B
Outer Edge of TLP Pro 525M Front Bezel
(Do not cut this line)
4.03" H x 5.95" W (102 mm H x 151 mm W)
Page size: 8.5" x 11"
Print scale 1:1
Do not shrink.
Outer Edge of TLP Pro 525M Mounting
Plate (Do not cut this line)
3.56" H x 5.59" W (90 mm H x 142 mm W)
TOP
WALL
WALL WALL
WALL
MK
MK
EU
/MK
EU
/MK
NORTH
AMERICA
NORTH
AMERICA
SURFACE
CUT-OUT
AREA
For complete installation instructions, see the
TLP Pro 525M, 725M, and 1025M Series Setup
Guide or the TLC Pro 526M, 726M and 1026M
Series Setup Guide (at www.extron.com).
/