Page size: 8½" x 11"
Print scale 1:1
Do not shrink.
68-3524-01 Rev. A
Cut-Out Template for the Extron
TLP Pro 300M
For complete installation instructions, see the
TLP Pro 300M Series Setup Guide (available
at www.extron.com).
1. Confirm the product to be installed.
2. Before printing, double-check the
print settings and make sure the page
is not scaled.
3. After printing, measure the cut-out area (gray)
and ensure the dimensions are the same as
those shown.
4. Cut along the red line to remove the surface
cut-out area (gray) from the template.
5. Mark the position on the mounting surface
where the TLP Pro 300M is being installed.
6. Double check dimensions and position,
then cut the opening.
A and B mark the positions of mounting screws.
These are only required if toothed clamping plates
are used for mounting (see the “Mounting” section
of theTLP Pro 300M Series Setup Guide, available
at www.extron.com).
SURFACE
CUT-OUT
AREA
Outer edge of touchpanel
(do not cut this line.)
1.75"
(44 mm)
2.80"
(71 mm)
0.35" (8.9 mm)
0.275" (7.0 mm)
0.35" (8.9 mm)
0.275" (7.0 mm)
A
B
/
