Extron RWM 1 Template

Page size: 8.5" x 11"

Print scale 1:1

Do not shrink.

1. Confirm the product to

be installed.

2. Double-check the print

settings, before printing.

Make sure the scale

settings are 1:1.

3. Remove the surface

cut-out area (gray) from

the template by cutting

along the red line.

DO NOT CUT the gray

dotted lines.

4. Measure the cut-out and

ensure it matches the

dimensions shown.

5. Mark the position on

the mounting surface

where the RWM 1 is

being installed.

6. Double-check position

and dimensions, then

cut the opening in the

wall.

Cut-Out Template for the Extron

RWM 1

P/N 68-3299-01 Rev. A

Outer Edge of RWM 1

(Do not cut this line.)

Outer Edge of TLP Pro 525M

(Do not cut this line.)

SURFACE

CUT-OUT

AREA

4.15"

(105 mm)

6.07"

(154 mm)