Extron TLP Pro 1720MG Template

Type
Template
7.25"
(18.42 cm)
0.825"
(2.10 cm)
0.825"
(2.10 cm)
11.00" (27.94 cm)
1. Confirm the product to be installed.
2
. Before printing, check the print settings
and make sure the p
age is not scaled.
3
. Remove the surface cut-out area (gray)
f
rom the template. (Keep these instructions.)
4
. Measure the cut-out and template.
5
. Mark the position on the mounting surface
where the
TLP Pr
o 1720MG is being installed.
6
. Check dimensions and position, then cut
the opening.
Page size: 11" x 17"
Print scale 1:1
Do not shrink.
SURFACE
CUT-OUT
AREA
6.25"
(15.88 cm)
9.25" (23.50 cm)
0.88"
(2.24 cm)
0.12"
(0.30 cm)
P/N 68-2700-01
Rev. A
The top left corner of this page aligns with the top left corner of the TLP Pro 1720MG bezel.
The bottom and right edges of the TLP Pro 1720MG bezel extend beyond the bottom and right edges of the paper.
Cut-Out Template for the Extron
TLP Pro 1720MG
  • Page 1 1

Extron TLP Pro 1720MG Template

Type
Template

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI