2. OPT7
  3. Redline Parlux Single Tailgate Light Bar
Redline Parlux Single Tailgate Light Bar

OPT7 Redline Parlux Single Tailgate Light Bar Installation guide

  • Hello! I have reviewed the Installation Guide for the OPT7 Redline Parlux Single Row Tailgate Light Bar (2PC). This document includes instructions on mounting the LED bar, connecting the wiring, and testing the functionality. I'm ready to answer your questions about the installation process or the features of this product.
  • What should I do if I experience error codes or dash lights?
    What should I do if I'm not familiar with my vehicle?
    Where to connect the reverse signal?
WHAT'S INCLUDED
Redline LED Bar
1X
Scotch-Lok Wiring Connectors
2X
Adhesive Promoter
1X 4X
14
YEAR
WARRANTY
2
DISCLAIMER
INSTALLATION
Test the Redline LED Bar again for function.
STEP8
Mounting Clips
900-00750
900-00701
Single Tailgate LED Light Bar
If you experience any error codes or dash
lights, please install the optional Tailgate
Module between the vehicle and Redline
LED bar sold separately.
OPT7 Lighting is not liable for damages, injuries, or death while installing this
product. The Installation Guide is intended as assistance to reduce setup time.
OPT7 Lighting assumes no responsibility for improper installation.
If you are unfamiliar with your vehicle or inexperienced with aftermarket
upgrades, please seek professional assistance.
3.2 ft
10 ft
Adhesive Booster
____
NOTE
REDLINE
PARLUX
SINGLE ROW TAILGATE LIGHT BAR (2PC)
INSTALLATION GUIDE
INSTALLATION
32
STEP6
STEP7 WHERE TO CONNECT THE REVERSE SIGNAL ?
TO REDLINE LED BAR
Ground
Running Light
Left Turn & Brake
Right Turn & Brake
White/Ground
Brown/Running Light
Yellow/Left Turn & Brake
Green/Right Turn & Brake
TRAILER HARDWIRE HARNESS
Plug the 4-pin flat connector into the proper
receptacle on the vehicle.
Refer to the wiring diagram below.
Splice the white wire coming from the Redline
LED Bar to the factory tail light or the 7PIN trailer
towing socket (Middle PIN) using the SCOTCH-LOK
wiring connector we provided.
Optional: If hard-wiring, use image below to identify wire color functions and
pair them to appropriately identified wires on vehicle.
REVERSE SIGNAL
WHITE WIRE _______________________________ _
PLUG THE CONNECTOR INTO THE TRUCK
THIS SIDE OF THE PLUG
STEP5
STEP4
Mark out where you want to mount
the included clips taking straightness
and placement into consideration.
1
2
Use the included screws and clips to solidly
mount the Redline LED bar to the vehicle.
______ _
OPTION 2
1
2
STEP3
STEP1
STEP2
Remove tailgate from vehicle
Test the Redline LED Bar for function before
mounting on vehicle.
Thoroughly clean the area where the Redline
LED Bar will be mounted.
______ _
ADHESION
PROMOTER STEP4
Apply the Adhesive Promoter to
the cleaned area.
STEP5
On the Redline LED Bar, peel the back
off of the adhesive and apply firmly to
the cleaned area.
OPTION 1
/