2. BLOTZ
  3. B15-CS-007

BLOTZ B15-CS-007 Assembly Instructions

  • I have reviewed the instructions for the BLOTZ Car Park B15-CS-007 extra level. This document provides a clear step-by-step guide on assembling the model, including how to attach the supports, upper level, ramp and small wall. I'm ready to answer any questions you might have about this model or its construction process.
  • What tools are needed for assembly?
    What is the purpose of this model?
    What should I use to hold pieces together while glue dries?
    How should I use the modeling knife?
15mm Car Park (Extra Level)
B15-CS-007
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and
remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
Each support is formed from the two pieces on
the left. Slot them together as shown on the
right.
Glue the supports to the underside of the upper level’s
floor.
Each end of the upper level is formed from the
pieces shown here.
Flue the short piece into place first.
Attach the ramp and small wall.
Add the outer section.
The completed upper floor.
The finished model shown on top of the Car Park
(B15-CS-006).
/