RF Single Color Wall Mounted Controller 09.286DU.04220
Function introduction
Important: Read All Instructions Prior to Installation
Front side
Rotate the knob counterclockwise
to decrease light intensity from
100% to 1%.
Rotate the knob clockwise to
increase light intensity
from 1% to 100%
Click the rotary knob
to switch ON/OFF light
Power supply
Protective film
Before the first use, please remove it
43.58 mm
65.58 mm
Back side
RF Single Color
Wall Mounted
Controller
83.00 mm
19.4 mm
Output Signal RF signal
Power Supply 3V(CR2032)
Power consumption 10 mA
Operating temperature 0-40°C
Relative humidity 8% to 80%
Dimensions 75x120x41.6mm
Product Data
Installation
• DO NOT install with power applied to device.
• DO NOT expose the device to moisture.
Safety & Warnings
• Rotation sensitive
• Glass interface(white & black)
• Compatible with all universal series RF receivers
• Radio frequency: 916.5MHz
• Control single color
• Control 1 zone of RF receiver
• Waterproof grade: Ip20
Pair with RF receiver
Step 3:Rotate or click the knob, LED lights connected with the RF receiver flicker once
means the receiver is paired with the remote successfully.
Step 2:Click the “Learning Key” button on RF receiver to set it into pairing status
Note: one receiver can be paired with max 8 remote controls.
Learning Key
RF LED Receiver
Step 1:Do wiring the RF receiver according to wiring diagram(please refer
to the instruction of RF receiver that you would like to pair with.
-
1
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Sunricher SR-2805R User manual
-
-
-
-
-
-
-
-
-
Other documents
-
Mark Levinson 32 Owner's manual
-
Extron MLC 104 IP Plus DV User manual
-
Quickie Q500 H Owner's manual
-
Mark Levinson 326S Owner's manual
-
NAD D 3045 User manual
-
Nice Apollo 4300SW Residential Swing Gate Operator Installation guide
-
Mark Levinson 320S Owner's manual
-
VocoPro KC-300 PRO Operating instructions
-
-
