Tools Required:
• /-inch wrench (or adjustable wrench)
Hook the “Z” end
of the clutch cable
into the tine
engagement lever
Hand Knob
Tine Engagement Lever
Depth Stake
Handle
Handle Brace
Remove the hex screw and bell washer
from the right side of the frame.
Insert the handle into the frame and attach
with the bolt and bell washer (cupped side in).
Note the location of the cable guide bracket
on the tiller frame. Refer to image in Step 2.
Tighten the bolt securely after attaching the
handle brace in Step 4
Secure the handle brace to the handle with the
bolt, hand knob and bell washer (cupped side in).
Securely tighten the bolt inserted in Step 3.
Remove the two hex washer screws
from the tail bracket.
Position the depth stake assembly within
the tail bracket and secure with the two
hex washer screws removed in Step 5.
778 -12368© 2012 21A-34M
1
4
2
5
3
6
READ AND UNDERSTAND ALL INSTRUCTION, WARNING, AND DANGER LABELS.
PARA INSTRUCCIONES EN ESPAÑOL, REFIÉRASE AL MANUAL DEL OPERADOR.
IMPORTANT: READ OPERATOR'S MANUAL AND ENGINE MANUAL THOROUGHLY
AND FOLLOW THE IMPORTANT SAFE OPERATION PRACTICES BEFORE OPERATING .
Need Help? Call 1-888-TO-HELP-U