2. Troy-Bilt
  3. 31AM62N2711
31AM62N2711

Troy-Bilt 31AM62N2711 Fast Start Guide

  • Hello! I am an AI chatbot trained to assist you with the Troy-Bilt 31AM62N2711 Fast Start Guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
  • How should I attach the chute assembly?
    How do I secure the chute control rod?
    How many times should I push the primer?
    Where should I move the throttle control to start the engine?
    What is the last step to start the engine?
    What should I do after the engine starts?
    In what order should I disconnect the cord?
Form No. 778-11820© 2009 31AM62N2
Chute Assembly
Handle Knobs
Chute Adapter
Upper Handle
Chute Control
Rod
Chute Bracket
Shift Lever
Place shift lever A.
into F6 position.
Pivot upper handle B.
into operating
position
Tighten handle C.
knobs.
A
B
C
Place chute assembly
onto chute adapter.
Close the three
flange keepers.
Keepers will click
into place when
properly secured.
Remove flat washer
and hairpin clip.
Insert chute control
rod into chute bracket.
Secure with washer
and clip.
1
3
2
4
READ AND UNDERSTAND ALL INSTRUCTION, WARNING, AND DANGER LABELS.
PARA INSTRUCCIONES EN ESPAÑOL, REFIÉRASE AL MANUAL DEL OPERADOR.
IMPORTANT: READ OPERATOR'S MANUAL AND ENGINE MANUAL THOROUGHLY AND
FOLLOW THE IMPORTANT SAFE OPERATION PRACTICES BEFORE OPERATING .
Need Help? Call 1-888-TO-HELP-U
Oil Fill /
Dipstick
Electric Starter
Button
Electric Starter
Outlet
Key
Primer
Key
Throttle
Control
Choke
Control
Gas Fill
Form No. 778-11820© 2009 31AM62N2
Move throttle control
into the Fast
position.
Move the choke control
into the Choke
position.
Connect power cord to A.
electric starter outlet.
Plug other end of power B.
cord into a three-prong
120-volt, grounded, AC
receptacle.
Push primer
three times.
Fill fuel tank with
clean, fresh gasoline.
Do not fill above the
base of fuel tank neck.
Check the oil level
using the dipstick.
Add oil if necessary.
(Refer to the
Operator’s Manual)
Insert the key into the
key switch until the
key snaps into place.
Do not turn the key!
To start engine, A.
push the starter
button.
When engine B.
starts, slowly move
choke control
into the Run
position.
Disconnect cord C.
from power
receptacle first and
then from snow
thrower’s outlet.
1
4
2
5
3
6
READ AND UNDERSTAND ALL INSTRUCTION, WARNING, AND DANGER LABELS.
PARA INSTRUCCIONES EN ESPAÑOL, REFIÉRASE AL MANUAL DEL OPERADOR.
IMPORTANT: READ OPERATOR'S MANUAL AND ENGINE MANUAL THOROUGHLY
AND FOLLOW THE IMPORTANT SAFE OPERATION PRACTICES BEFORE OPERATING .
Need Help? Call 1-888-TO-HELP-U
/