Inspect the shipping container contents for damage and to determine that all components and hardware are present.1.

NOTE: Before assembling the nuts to the bolts, it is

recommended that a light oil or petroleum jelly be applied to

the screw threads.

mounting holes of the ange.

Place a at washer on one of the 1 1/4" hex head bolts and insert

the bolt through one of the mounting holes in the table top

mounting ange and the table top support. Place a at washer

and nylock nut on the end of the bolt and tighten it nger tight.

Repeat this process on the other side of the table top support.

Leave the hardware nger tight so adjustments can be made

during assembly.

Locate the rubber feet and insert one in each of the two outside

holes on the bottom of each of the table top supports.

Use the rubber mallet to set the feet if necessary.

Locate the cross brace and position it in the center of the table top supports so that the mounting holes in the brace line up

with the mounting holes in the supports.

Place a at washer on one of the 2 1/2" Phillips head screws and insert the screw through one of the table top mounting holes

and through the matching hole in the cross brace.

Place a at washer on the screw and then tighten it nger tight with a nylock nut.

Repeat this process for the three remaining cross brace mounting holes.