Assembly Instructions
anovafurnishings.com
800.231.1327 tel
Component parts:
Hardware Needed:
Assembly:
1
1. Inspect the shipping container contents for damaged or missing components.
2. Lay all parts on a soft work surface or on the shipping packaging to prevent damage to nish.
NOTE: Before assembly, it is recommended that a light oil or petroleum jelly be applied to screw threads.
Tools Needed:
• 3/4” Hex Wrench
• 3/4 Hex Socket with Ratchet
• Retractable Measuring Tape
• Pencil
F2030 - 2-1/2’ Expanded Steel Bench, Portable
2-1/2’ Expanded Steel Bench, Portable
Cross Brace Seat Legs
Hex Head Bolt
5/16” x 1-1/4” Stainless
Steel
Nylock Nut
5/16”-18
316 SS
Flat Washer
5/16”
Stainless Steel
Rubber FootHex Head Bolt
5/16” x 3”
Stainless Steel
Assembly Instructions
2-1/2’ Expanded Steel Bench, Portable
2
3. Locate the leg and two rubber feet and place them
as shown.
4. Insert the two rubber feet into the bottom of the
leg. Use a rubber mallet if necessary.
5. Repeat steps 3 and 4 with the remaining leg and
rubber feet.
6. Mount a leg to the bench seat by inserting two
1-1/4” hex head bolts and two at washers through
the mounting holes of the bench seat and the leg.
Place a washer and nylock nut on each bolt and
tighten nger tight.
Repeat this step to attach the remaining leg.
3
4
6a
6b
6c
Assembly Instructions
2-1/2’ Expanded Steel Bench, Portable
3
• Furniture must not be used other than for its intended purpose and should be inspected regularly for loose, missing, or
broken hardware, and general instability
• Furniture that is damaged or appears to be unstable must be removed from service and repaired or replaced
• Repairs must be made using only factory authorized parts and methods.
WARNING
• Do not drag the assembled unit across any surface.
• This product requires only periodic cleaning with a sponge and a solution of mild detergent and water to remove surface
dirt. Do not clean with a solvent or petroleum based products.
CARE AND
MAINTENANCE
Note: Please contact Customer Care at 1-866-797-1761 when ordering replacement parts.
12/12/2022 Copyright 2022 Anova ® Manufactured in the U.S.
7. Mount a cross brace to a leg by inserting one
3” hex head bolt and a at washer through the
mounting holes. Place a at washer and nylock nut
on the end of the bolt and tighten nger tight.
Repeat this step to mount the remaining cross
braces on the other leg.
a. Align the cross brace with the mounting
hole on the bench. Insert one 1-1/4” hex
head bolt and a at washer through the
mounting hole. Place a at washer and
nylock nut on the end of the bolt and
tighten nger tight.
8. Turn the bench upright and move it to desired
location.
7a
7b
7c
Replacement Parts
Bench
Leg
Cross
Brace
/
