FläktGroup EQPF HEPA Filter Installation guide

Type
Installation guide
FläktGroup Specifications are subject to alteration without notice
GENERAL
As dust is gradually collected in the filter, the flow resistance of
the filter correspondingly increases. This causes a reduction in
the airflow. The filter must therefore be changed regularly, at inter-
vals determined by the dust concentration in the air.
Indication of when the filter should be changed is indicated by an
electric signal from some type of filter monitor.
A set of replacement filters should be available for every instal-
lation. This also applies to cleanable filter mats, since when the
mats that have been in service must be cleaned, the spare mats
can be fitted thus preventing stoppage of the system.
TO CHANGE THE EQPF HEPA FILTER
When installing the filter, make sure that the filter cassettes are
not damaged. Each filter has a sealing strip.
When installing, check that the sealing strip and corresponding
parts in the frame and the filter cassette are clean and are not
damaged. Place the filter into position and tension the filter
holders. See the figure below.
WARNING!
Dust from dirty filters can be a health hazzard,
wear face mask (lowest class FFP2) when
handling.
Dirty filters must be disposed of an environ-
mentally responsible way accordance with
local regulations.
HEPA filter
Filter
Filter-
holder
EQPF HEPA FILTER
INSTALLATION AND MAINTENANCE
DC_9106GB 20181017_R1
EQPF HEPA FILTER
Installation and maintenance instructions
2
FläktGroup DC_9106GB 20181017_R1Specifications are subject to alteration without notice
TO ORDER REPLACEMENT FILTERS
Replacement filters can be ordered from your nearest FläktGroup
sales representative.
Unit
size
Filter dimensions and
Filter arrangement
Unit
size
Filter dimensions and
Filter arrangement
005
592x287
041
3x(592x592) + 3x(592x287)
008
792x392
045
4x(592x592) + 2x(287x592)
009
592x592
050
8x(492x492)
011
2x(492x492)
054
6x(592x592)
014
592x592 + 287x592
056
4x(592x592) + 2x(592x287) +
2x(287x592) + 287x287
018
2x(592x592)
063
6x(592x592) + 2x(287x592)
020
592x592 + 287x592 +
592x287 + 287x287
068
3x(592x592) + 3x(592x287)
023
2x(592x592) + 287x592
072
8x(592x592)
027
2x(592x592) + 2x(592x287)
079
6x(592x592) + 3x(592x287) +
2x(287x592 + 287x287
032
4x(392x792)
090
8x(592x592) + 4x(592x287)
036
4x(592x592)
EQPZ-24-bbb-c-d-1
Replacement filter for the
EQPF HEPA filter, Filter
cassettes (set)
Unit size (bbb)
005-216
Filter class (c)
1 = H10
2 = H12
3 = H13
4 = H14
Cassette material (d)
1 = plywood
2 = galvanised sheet steel
3 = stainless sheet steel
  • Page 1 1
  • Page 2 2

FläktGroup EQPF HEPA Filter Installation guide

Type
Installation guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI