![](//vs1.manuzoid.com/store/data-gzf/f46e28b65ffc2672e550591ee50e6774/2/002198372.htmlex.zip/bg2.jpg)
2HermanMiller for Cosm chair Dissembly and Reassembly Instructions1BKJD4 rev A
Step Step
. Using flat screw driver, li up and pull out the tilt housing cover. . slide in the flat screw driver from back of the tilt and catch the back
edge of cable actuator housing.
. Pry down and pop the control loose to take out.
. Using power drive with mm hex bit which needs to be inches long to
take out the arm from the chair.
Step Step
. Place the pound quick clamp with jaws reversed in between the
frames of the chair and gently clamp until some resistance.
Note: Don’t over stretch the frame.