Energy Suspension 2.4102G2.4102G Operating instructions

Type
Operating instructions
POSITION # 1
POSITION # 2-4-5-6 POSITION # 3
INST.# 17032
Updated 04/01/03 APP
One extra mount
used on CJ8
4016 and 4020
Must re-use original hardware.
4016
4020
OEM Bottom
Frame
Front of vehicle
6
5
4
3
2
1
Spray all nuts to be removed
generously with your favorite rust
buster.
Note: When disassembling, note the quantity
and positions of any shims that may have been
inserted for body alignment. These shims will
have to be reused to insure proper body
alignment.
Remember: Only raise body high enough to
remove & replace mounts. Always watch the
fan shroud for sufficient clearance when
raising the body. When jacking the body use a
long enough 2X4 or 4X4 for maximum support.
Never put jack directly on body panels.
Install mounts one side at a time with bolts on
other side loosened only.
Retorque to factory specs.
Removal
Set # 2-4102 and 2-4104
OEM Top
OEM Top
OEM Top
Frame
4017
4019
OEM Bottom 4016
Frame
4018
OEM Bottom
CJ8 Scrambler only
1131 VIA CALLEJON, SAN CLEMENTE, CA 92673
R
Updated 13/DEC/01 BRH
2002 Energy Suspension. All rights reserved.2002 Energy Suspension. All rights reserved.
CC
May not be reproduced, in any form, or by any means,
without the written consent of Energy Suspension.
May not be reproduced, in any form, or by any means,
without the written consent of Energy Suspension.
Note: It is recommended that this set be professionally installed if you are unfamiliar with this type of work, and a factory
service manual be purchased prior to performing any work on your vehicle for proper disassembly, reassembly and torque
specs. These instructions are intended for bushing removal and install of Energy Suspension polyurethane bushings, once
you have removed the factory component from your vehicle.
  • Page 1 1

Energy Suspension 2.4102G2.4102G Operating instructions

Type
Operating instructions

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI