2. AMG
  3. AMG2223L

AMG AMG2223L Instruction Sheet

  • Hello! I have reviewed the Instruction Sheet for the AMG2223L standalone three-channel video fiber optic transmitter. This document provides specifications about its video and optical connections, power requirements, and dimensions. I'm ready to answer any questions you have about this device.
  • What type of video connectors does the device use?
    What is the nominal wavelength of the optical transmission?
    What is the typical launch power for 50/125 fiber?
AMG Systems Ltd. reserves the right to make changes to this document without notice.
The information herein is believed to be accurate. No responsibility however is assumed
by AMG for its use.
Page 1 of 2 D04197-01
AMG2223L
Instruction Sheet
AMG2223L 1300nm Standalone Three Channel Video Only Fibre Optic Transmitter
Video Connection
Connectors ...........................75 ohm BNC Socket.
Input Impedance...................75 ohm terminated.
Input Level ...........................1 volt p-p nominal.
Frequency Response.............10Hz to 10MHz min.
Optical Connection
Connectors............................ST Style
Launch Power
50/125............................-20dBm min. -17dBm typ.
62.5/125.........................-17dBm min. -14dBm typ.
Wavelength...........................1300nm nominal.
~193mm
~54mm
Slot size 4.5mm x 10mm
VIDEO IN 1
VISION2000
FIBRE TRANSMITTER
DC IN
+15V @ 200mA
FRONT PANEL INDICATORS
POWER
OPTOOUT 3
OPTOOUT 2
OPTOOUT 1
VIDEO IN 2
VIDEO IN 3
~200mm
~100mm
AMG Systems Ltd. reserves the right to make changes to this document without notice.
The information herein is believed to be accurate. No responsibility however is assumed
by AMG for its use.
Page 2 of 2 D04197-01
Power Connection
Supply...................................+12 volts D.C. to +18 volts D.C. 250mA
Connection ...........................2 Pin Latching Lemo Connector
AMG Pt No. G0003000
Lemo Pt No. ERA05302CCL
Polarity
1
2
1
1
22
- 0v
- +ve
Dimensions
See Drawing above.
Mounting Details
See Drawing above.
Always allow for bend radius of optical and electrical cables when mounting.
Indicators
Power....................................Green – lit when unit powered
/