2. AMG
  3. AMG2321

AMG AMG2321 Instruction Sheet

  • Hello! I have analyzed the instruction sheet for the AMG2321 Mini Video Only Fibre Optic Transmitter. This document provides details about its video and optical connections, power requirements, dimensions, and mounting instructions. The transmitter is designed for use with multimode optical fiber. I'm ready to answer any specific questions you might have about this device.
  • What type of connector is used for video input?
    What is the nominal input level?
    What type of optical connector is used?
    What is the required power supply for the device?
    What are the mounting options?
AMG Systems Ltd. reserves the right to make changes to this document without notice.
The information herein is believed to be accurate. No responsibility however is assumed
by AMG for its use.
Page 1 of 1 D04502-01
AMG2321
Instruction Sheet
AMG2321 Mini Video Only Fibre Optic Transmitter
The AMG2321 is a miniature transmitter designed
to transmit video signals over multimode optical
fibre.
Video Connection
Connector ............................75 ohm BNC Plug
Input Impedance...................75 ohm terminated
Input Level ...........................1 volt p-p nominal
Frequency Response.............10Hz to 10MHz min.
Optical Connection
Connector .............................ST Style
Launch Power
50/125 Fibre ..................-20dBm min. -17dBm typ.
62.5/125 Fibre ...............-17dBm min. -14dBm typ.
Wavelength...........................850nm nominal
Power Connection
Supply...................................+12 volts D.C. to +18 volts D.C. 30mA
Connection ...........................Two core flying lead.
Polarity .................................Ridged wire positive.
Dimensions
Length...................................42mm plus connectors
Diameter ............................... 17mm.
Mounting Details
The 2321 is designed to connect directly to a camera video output BNC connector.
It can also be connected at the end of a coaxial drop cable with the use of a 75 ohm jack to
jack in-line BNC adapter and mounted using of a 17mm P-Clip.
Always allow for bend radius of optical and electrical cables when mounting.
There is no adjustment required when using this product.
AMG
2321
Fibre Optic
Video Transmitter
/