2. AMG
  3. AMG2211L

AMG AMG2211L, AMG2211 Instruction Sheet

  • Hello! I'm a chat assistant and I've analyzed the Instruction Sheet for the AMG2211L Fibre Optic Receiver. This document provides technical details regarding the device, including its connection types, power requirements, and key features like long-distance video transmission and fiber optic connectivity. I'm ready to assist you with any questions you may have.
  • What type of video connector does the device use?
    What type of optical connector does the device use?
    What is the required power supply?
AMG Systems Ltd. reserves the right to make changes to this document without notice.
The information herein is believed to be accurate. No responsibility however is assumed
by AMG for its use.
Page 1 of 2 D04094-03
AMG2211L
Instruction Sheet
AMG2211L Standalone Single Channel Long Distance Video Only Fibre Optic Receiver
Video Connection
Connectors ...........................75 ohm BNC Socket.
Output Impedance ................75 ohm terminated.
Output Level.........................1 volt p-p nominal.
Frequency Response.............10Hz to 10MHz min.
Optical Connection
Connectors............................ST Style
Receiver Sensitivity
Gain ...................................... Up to –30dBm nominal.
No Customer adjustments are available within the unit.
Wavelength...........................1300nm nominal.
Power Connection
Supply...................................+15 volts D.C. to +18 volts D.C. 250mA
Connection ...........................2 Pin Latching Lemo Connector
AMG Pt No. G0003000
Lemo Pt No. ERA05302CCL
Polarity
1
2
1
1
2 2
- 0v
- +ve
~193mm
~54mm
Slot size 4.5mm x 10mm
VIDEO OUT 1
VISION 2000
FIBRE RECEIVER
DC IN
+15V @ 200mA
FRONT PANEL INDICATORS
POWER
OPTO IN1
SYNC VIDEO
~215mm
~115mm
AMG Systems Ltd. reserves the right to make changes to this document without notice.
The information herein is believed to be accurate. No responsibility however is assumed
by AMG for its use.
Page 2 of 2 D04094-03
Dimensions
See Drawing on page 1.
Mounting Details
See Drawing above.
Always allow for bend radius of optical and electrical cables when mounting.
Indicators
Power....................................Green – lit when unit powered
Video Sync ...........................Green – lit when video signal present on optical input.
/