AMG Systems Ltd. reserves the right to make changes to this document without notice.
The information herein is believed to be accurate. No responsibility however is assumed
by AMG for its use.
Page 1 of 2 D04064-04
AMG2213
Instruction Sheet
AMG2213 Standalone Three Channel Video Only Fibre Optic Receiver
Video Connection
Connectors ...........................75 ohm BNC Socket – 3 off.
Output Impedance ................75 ohm terminated.
Output Level.........................1 volt p-p nominal.
Frequency Response.............10Hz to 10MHz min.
Optical Connection
Connectors............................ST Style – 3 off
Receiver Sensitivity
Gain............................... Up to –30dBm nominal.
No Customer adjustments are available within the unit.
Wavelength...........................850nm nominal.
Power Connection
Supply...................................+15 volts d.c. to +18 volts d.c. at 250mA
Connection ...........................2 Pin Latching Lemo Connector
AMG Pt No. G0003000
Lemo Pt No. ERA05302CCL
Polarity
1
2
1
1
22
- 0v
- +ve
~193mm
~54mm
Slot size 4.5mm x 10mm
VIDEO OUT 1
VISION 2000
FIBRE RECEIVER
DC IN
+15V @ 200mA
FRONT PANEL INDICATORS
POWER
OPTO IN3
OPTO IN2
OPTO IN1
VIDEO OUT 2
VIDEO OUT 3
SYNC VIDEO
CH1
CH3
CH2
~215mm
~115mm
AMG Systems Ltd. reserves the right to make changes to this document without notice.
The information herein is believed to be accurate. No responsibility however is assumed
by AMG for its use.
Page 2 of 2 D04064-04
Dimensions
See Drawing above.
Mounting Details
See Drawing above.
Always allow for bend radius of optical and electrical cables when mounting.
Indicators
Power....................................Green – lit when unit powered
Video Sync ........................... Green – lit when video signal present on optical input.
/